Then switch to a Grey Ultra fine scotch brite pad on the orbital sander and go over the piece again. You will notice a very fine white dust on the surface. Once fully dry, mechanically sand (orbital is what I use) with 800 Grit wet and dry paper. Thoroughly vacuum the roller first to remove any loose fibres.Īpply the Osmo as thinly as possible to the piece - roller on flat surfaces, and a soft brush elsewhere.Īpply the second coat in the same manner - applying as thinly as possible. I use a mohair or microfibre roller to apply - short nap. No need to go further than that in my experience. Sand everything to 180 Grit minimum, 220 preferred. To clarify, I'll describe my technique for applying Osmo, and that may help you to understand my process: Osmo is definitely my preferred product - easy to apply, leaves a great finish with minimum fuss, is durable and repairable. I've been using Osmo and other hardwax oil products for over 10 years, on both floors and joinery, including plywood and solid timber. Any suggestions would be greatly appreciated! I know that people use Osmo for tables so there must be something that I am missing. Being a floor finish I would have expected it to be more durable to water marks and as a finish for a tabletop that will see daily use I need something that can handle a bit of moisture without ruining the finish. I tried to spot repair the water spot with Osmo which brightened up the surface but left the water spot visible. I then wetted the surface (with water) and wiped it off immediately which left the finish looking dull. I have made a couple of test boards and applied the Osmo using a couple of different methods and aesthetically they look ok (not dazzling, but ok) but my biggest concern is that after having cured for at least three weeks I left a droplet of water on the surface for about 20 minutes, wiped it off and it left a spot. I’m wondering what it is that I may be missing. Osmo promises to be all these things and seems to get excellent reviews but I must say that I have been rather disappointed with my test results. There is a 12 hour drying time under normal climatic conditions for Osmo Wood Wax Finish Clear Extra Thin.I am building a dining table in cherry and am wanting to use a nice wipe on finish that is user friendly, durable, and of course something that will look great. To clean your tools you can use Osmo Brush Cleaner.įor a high-sheen effect and extra durability you can apply one coat of Wood Wax Finish Clear Extra Thin as a base coat, and use Polyx-Oil for the second coat. If you are finishing cupboards, wardrobes and drawers only one thin coat is necessary and should be applied with a cloth. Re-coat areas that are not sufficiently treated.Ģnd coat: Apply thinly. Leave to dry for approximately 30 minutes. Leave to dry for approximately 30 minutes. Apply evenly along the wood grain with a brush or cloth.ġst coat: Apply thinly. To apply the finish you can brush, wipe, dip or spray (in closed chambers). We always suggest a sample trial before finishing your entire surface. thoroughly from the surface with a brush or vaccuum cleaner before application. Sand carefully before application, starting with course paper and finishing with P120 – P150 for flooring and P180 – P240 for furniture. Small cracks, larger dents, and small holes can be filled in with Osmo Woodfiller. Make sure to always wear a dust mask when sanding. Clean or slightly sand old microporous finishes and remove old varnish (with Osmo Paint Remover or sanding). Osmo Wood Wax Finish Clear Extra Thin is ready to use, do not thin. To apply this the wood surface must be clean, dry and frost-free (maximum 18% wood moisture).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |